Loading ...
Loading ...
Loading ...
User Manual 08
Installation Instructions
POWER SOURCE AND GROUNDING
It’s recommended to use the dryer on it’s own dedicated power outlet for both convenience and safety. The power outlet
must be grounded.
Important! If the power cord is damaged, it must be replaced by Residentia Group or one of it’s authorised
service representatives. Please contact 1300 11 HELP (4357) and ensure the appliance is completely
disconnected from the power supply.
SIMPLE INSTALLATION:
—See diagrams on page 09
→ Step 1: Dryer should be placed in a ventilated area with a minium of 80mm
between the top of the dryer and ceiling and with no less than 10cm
distance from the wall or cabinetry. It is also recommended that there are
no obstacles within 1.5m of the dryers front, to ensure ease of operation
and ventilation.
Determine a location to mount the dryer and attach both horizontal and
vertical screw position templates to the wall (Fig. 1). Ensure each bracket
position can be securely fastened (eg. Into the stud). Fit timber slats (not
supplied) if necessary.
→ Step 2: Fix the wall hanging brackets and both left/right support brackets to the
wall securely in accordance with the template (Fig. 2).
– Ensure power cord and plug is accessible and reaches a power source.
– Mounting Into Wood: Fix all brackets to the wall securely (eg. Into the
stud) with M8012 expansion screw (not supplied). Fit additional timber
slat(s) (not supplied) between the studs to mount the bracket onto if
the stud position is too wide.
– Mounting Into Concrete: Drill 8 holes on the wall with the diameter of
012 according to the screw position templates. Fix all brackets to the
wall securely with expansion screw bolts supplied.
→ Step 3: With assistance, mount the dryer on wall bracket, upright or inverted
depending on personal preference.
WARNING: Weight Hazard. Two or more people required to lift
and install the dryer.
– Ensure brackets are xed to the wall securely.
– Ensure hanging brackets are pushed into position and dryer is placed
on the support brackets before slowly releasing the full weight onto
the brackets (Fig. 3).
→ Step 4: Remove and then replace the control panel with the supplied inverted
control panel. Install the plastic cover on the top of the dryer.
→ Note: Use a spirit level to ensure that your dryer is horizontally level, whether
it be on the ground or wall mounted. As with all appliances with moving
internal parts, it’s essential that the dryer is level as it will eect it’s
balance and operation.
Important! Please ensure that the dyer is only ever installed in an internal environment only (and not outside), or an
environment where the dryer could become wet. Never place the dryer near combustible surfaces (such
as curtains) and ensure the dryer isn’t operating near gas or other ammable materials.
Loading ...
Loading ...
Loading ...