Loading ...
14
en
use
Description
The terminology below will be used repeatedly on the
following pages.
Description of the appliance
(see page 2)
A1. Steam dial
A2. ON/OFF button
A3. ON light
A4. Coee or hot water button
A5. Temperature OK for coee/hot water light
A6. Steam button
A7. Temperature OK for steam light
A8. Boiler outlet
A9. Cup tray
A10. Drip tray
A11. Cappuccino maker
A12. Steam or hot water spout
A13. Power cable
A14. Cup shelf
A15. Water tank
Description of the accessories
(see page 2)
B1. 1 cup lter ( )
B2. 2 cups lter ( )
B3. Pod lter ( )
B4. Filter holder
B5. Coee measure/tamper
Installing the appliance
When you install the appliance, you should respect the
following safety warnings:
• Water penetrating the appliance could cause damage. Do
not place the appliance near taps or sinks.
• The appliance could be damaged if the water it contains
freezes.
• Do not install the appliance in a room where the
temperature could drop below freezing point.
• Arrange the power cable in such a way that it cannot be
damaged by sharp edges or contact with hot surfaces
(e.g. electric hot plates).
Connecting the appliance
Danger!
Check that the mains power supply voltage corresponds to that
indicated on the rating plate on the bottom of the appliance.
• Connect the appliance to an eciently earthed and
correctly installed socket with a minimum current rating
of 10 A.
• If the power socket does not match the plug on the
appliance, have the socket replaced with a suitable type
by a qualied electrician.
• The power cable on this appliance must not be replaced by
the user as this operation requires the use of special tools.
If the cable is damaged or requires replacing, contact the
De’Longhi’s Customer Experience only to avoid all risks.
Filling the water tank
1. Open the water tank lid (g. 1), then take out the tank by
pulling upwards (g. 2).
2. Fill the tank with fresh clean water, taking care not to
exceed the MAX level (g. 3). Replace the tank, pressing
lightly downwards (to open the valve located on the
bottom of the tank).
3. Alternatively, the tank can also be lled without removing
it, pouring the water directly from a jug.
Important:
Never use the appliance without water in the tank and always
remember to top up when the level drops to a couple of
centimetres from the bottom.
Please note:
It is normal for there to be water in the space under the tank.
This should therefore be dried regularly with a clean sponge.
Auto-o
To save energy, an auto-o function turns the coee maker o
(light A3 goes o) when not used for a long period.
To turn the appliance on again, press the ON/OFF button (g.
4).
How to make coee
Setting up the appliance
The rst time you use the appliance, rinse the internal circuits
by proceeding as though you were making coee (without the
need for using coee) until you have used at least two tanks of
water. You can then make coee.
Preheating the coee unit
To make espresso coee at the right temperature, the coee
maker should be preheated as follows:
1. Turn the appliance on by pressing the ON/OFF button (the
ON light comes on) (g. 4) and attach the lter holder to
the appliance without adding pre-ground coee (g. 5).
2. Place a cup under the lter holder (g. 11).
Use the cup you will later use to make the coee in order
to preheat it.
3. Wait for the OK light to come on (g. 6), then immediately
press the coee button (g. 7). Allow the water to ow
Loading ...
Loading ...
Loading ...