Loading ...
Loading ...
Loading ...
6
Drain System
The washer can be installed using the standpipe drain system
(floor or wall), the laundry tub drain system, or the floor drain
system. Select the drain hose installation method you need.
See “Tools and Parts.”
Standpipe drain system - wall or floor (views A & B)
The standpipe drain requires a minimum diameter standpipe of
50 mm (2"). The minimum carry-away capacity can be no less
tha
n 45.5 L (12 gal.) per minute.
The top of the standpipe must be at least 762 mm (30") high and
no
highe
r than 2.4 m (96") from the bottom of the washer.
762 mm
(30" min.)
A B
Laundry tub drain system (view C)
The laundry tub needs a minimum 76 L (20 gal.) capacity. The top
of the laundry tub must be at least 762 mm (30") above the floor.
Floor drain system (view D)
The floor drain system requires a siphon break that may be
purchased separately. See “Tools and Parts.”
The siphon break must be a minimum of 710 mm (28") from the
bottom of the washer. Additional hoses might be needed.
762 mm
(30" min.)
710 mm
(28" min.)
C D
Electrical Requirements
■ A 220-240V, 50 Hz., fused electrical supply is required. A
time-delay 10-16A fuse or circuit breaker is recommended.
■ This washer is equipped with a power supply cord having an
earthed plug.
■ To minimize possible shock hazard, the cord must be
plugged into an earthed socket outlet, earthed in accordance
with local codes and ordinances. If a mating outlet is not
available, it is the personal responsibility and obligation of the
customer to have the properly earthed outlet installed by a
qualified electrician.
■ If codes permit and a separate earth wire is used, it is
recommended that a qualified electrician determine that the
earth path is adequate.
■ If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent, or a qualified person to avoid
a hazard.
■ Do not earth to a gas pipe.
■ Check with a qualified electrician if you are not sure the
washer is properly earthed.
Loading ...
Loading ...
Loading ...