Loading ...
Loading ...
Loading ...
20
Troubleshooting
Checking the Components of the
Electronic Ignition System
When pressing the ignition button you should hear a
ticking sound. If you cannot hear the ticking sound,
check the battery, then check the wires.
Checking the Battery
There are three potential issues with the battery that
supplies the power to your ignition module that need
to be checked:
1) Some batteries have a plastic protective wrap
around them. (Do not confuse this plastic with
the battery label.) Check that this plastic wrap is
removed.
2) Confirm that the battery is installed correctly (C).
3) If the battery is old, replace it with a new battery.
C
25 36 41
2
4
5
6
1
3
Igniter Module Wire Chart
CALL
CUSTOMER
SERVICE
If you are still experiencing any
problems, contact the CustomerService
Representative in your area using
the contact information on
weber.com.
Checking the Wires
There are two potential trouble spots that need to be
checked:
1) Check that the ignition wires are connected
securely to the terminals on the ignition button
under the control panel.
2) Make sure the ignition wires are properly attached
to the ignition module. The wire terminals are
colour coded to correspond with the terminals on
the ignition module. The number of wires will vary
per model.
GREASY BARBECUE (Peeling Paint & Flare-Ups)
SYMPTOM
• Inside of lid appears to have the appearance of peelingpaint.
CAUSE SOLUTION
The flakes you see are accumulated cooking vapours
that have turned into carbon.
This happens over time after repeated use of your
barbecue. This is not a defect. Clean the lid. Refer to
the “Product Care” section.
SYMPTOM
• Experiencing flare-ups when barbecuing or preheating.
CAUSE SOLUTION
There is leftover food from the previous meal. Preheat the barbecue on the highest setting for 10 to
15 minutes.
The inside of the barbecue needs to be cleaned
thoroughly.
Follow the steps in the "Cleaning and Maintenance"
section to clean the barbecue inside from the top
down.
Loading ...
Loading ...
Loading ...