Loading ...
Loading ...
Loading ...
Positioning and connecting en
29
Water inlet
:Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Do not immerse the Aqua-Stop safety
valve in water (it contains an electric
valve).
Observe the following when connecting
the machine:
Notes
■ With a cold water connection, only
operate the washing machine using
cold mains water.
■ With a hot water connection, operate
the washing machine with hot and
cold mains water, with a maximum
temperature of 60 °C.
■ Do not connect the machine to the
mixer tap of an unpressurised hot-
water boiler.
■ Do not use a used supply hose. Only
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
■ Do not bend, squash, modify or cut
through the water supply hose
(otherwise its strength is no longer
guaranteed).
■ Only tighten the screw connections
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may become
damaged.
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow is
at least 8 l/min.
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
Hot and cold water connection
Note:
■ Red hot water supply hose on the
hot water tap and red valve on the
appliance
■ Cold water supply hose on the cold
water tap and white valve on the
appliance
Connection to the water pipes (¾" =
26.4 mm)
Connection to the appliance
Cold water connection only
If no hot water connection is present,
only connect the cold water inlet hose
and cover the hot water connection on
the appliance so that it is kept free of
dirt
Note: Carefully turn on the tap and
check that the connection points are not
leaking. The screw connection is under
water pipe pressure.
Loading ...
Loading ...
Loading ...