Loading ...
Loading ...
Loading ...
9
Check proper electrical supply. Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet and that the polarity is correct.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Normal washer operation. Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Washer may be tightly packed. Press START (PAUSE/UNLOCK) for 3seconds and wait for lid to
unlock. Remove several items, rearrange load evenly in basket,
and add detergent. Close lid and press START.
Do not add more than 1 or 2 additional items after cycle has
started to avoid tightly packing or unbalancing.
All LEDs remain lit Error code. Try unplugging washer for 10 seconds and plug it back in to
reset the control.
Check for proper water supply per above.
Washer not
draining/spinning,
loads are still
wet, or spin light
remains on
(indicating that the
washer was unable to
pump out water within
10 minutes)
Small items may have been caught
in pump or between basket and tub,
which can slow draining.
Empty pockets and use garment bags for small items.
Use a cycle with a low spin speed. Cycles with lower spin speeds remove less water than cycles
with high spin speeds. Use the recommended cycle/spin speed
for your garment. To remove extra water in the load on a nonpay
model, select Final Spin. Load may need to be rearranged to
allow even distribution of the load in the basket.
The washer may be tightly packed
or unbalanced.
Tightly packed or unbalanced loads may not allow the washer
to spin correctly, leaving the load wetter than normal. Evenly
arrange the wet load for balanced spinning on a nonpay model.
Select the Final Spin cycle to remove excess water. See “Using
Your Washer” for loading recommendations.
Check plumbing for correct drain
hose installation. Drain hose
extends into standpipe farther
than 4.5" (114mm).
Check drain hose for proper installation. Use drain hose form
and securely attach to drainpipe or tub. Do not tape over drain
opening. Lower drain hose if the end is higher than 96" (2.4 m)
above the oor. Remove any clogs from drain hose.
Too much detergent causing suds to
slow or stop draining and spinning.
Always measure and follow detergent directions for your load.
To remove extra suds on a nonpay model, select Rinse & Spin.
Do not add detergent.
Dry spots on load
after cycle
High-speed spins extract more
moisture than traditional top-load
washers.
The high spin speeds combined with airow during the nal spin
can cause items near the top of the load to develop dry spots
during the nal spin. This is normal.
Loading ...
Loading ...
Loading ...