Loading ...
Loading ...
Loading ...
6
INSTALLATION
1. To ensure adequate ventilation for your refrigerator, it
is recommended to provide space of 60mm on both
sides and at the back, and space of 90mm above the
refrigerator. Insufficient spacing will decrease cooling
efficiency, increase energy consumption and may
reduce the life of the unit (see page 7).
2. Using the two front adjustable feet, ensure that the
refrigerator is positioned firmly and level on the floor.
Adjustable feet
3. Using the adjustable feet, raise the front of the unit so it
leans back slightly, this will assist in door closing. Make
final adjustments to ensure that the doors are correctly
aligned.
When the left
door is raised
When the right
door is raised
Lower the foot
at right side*
Lower the foot
at left side*
*Until the adjustable foot on the
other side is slightly off ground.
4. Remove the 4 screws from the bottom of the
refrigerator and use these to fit the kickplate (supplied
inside the refrigerator compartment).
Screw
(4 screws)
Screw
Kickplate
5. Connect the power plug to a 240 volt 10 amp
powerpoint.
NOTES:
Position your refrigerator so that the plug is accessible.
Keep your refrigerator out of direct sunlight.
Do not place next to a heat generating appliance.
This refrigerator is designed for indoor use only – do not
place the unit on an unsealed surface.
To avoid vibration and misalignment of the doors, the
unit must be level. Place the unit on a solid flat surface.
Uneven floors eg. slate, tiles and floorboards, can cause
the unit to sag over time causing the doors to
become misaligned.
If the mains power is switched on when the door is
open, the door alarm will sound. Close the door to
stop the alarm.
Wipe up water in the evaporating pan. Before wiping up
the water, wait more than 1 hour after pulling out the plug
because refrigeration cycle equipment is extremely hot.
(The evaporating pan is located at the rear of the product.)
Evaporation pan
• Usingtherollers,itispossibletomovebackandforth.
Carry the refrigerator by the holding devices located on
the rear and bottom.
• Cleantheinsidepartswithaclothsoakedinwarm
water. If soapy water is used, wipe it off thoroughly.
Loading ...
Loading ...
Loading ...