Loading ...
Loading ...
Loading ...
4.
5.
Slide the compression nut over the sleeve and screw into the
water valve inlet port.
/ ...............................................................
.....A
....... C
.........a
A. Plastic water C. Compression nut
tubing D. Copper tubing
B. Sleeve
Using an adjustable wrench, hold the nut on the plastic
water line to keep it from moving. Then, with a second
wrench turn the compression nut on the copper tubing
counterclockwise to completely tighten. Do not overtighten.
..... C
ql
A. "P" clamp
B. Plastic water line
C. Compression nut
D. Copper tubing
6. Check connection by pulling on copper tubing. Attach the
plastic water line to the refrigerator cabinet with a "P"
clamp.
7. Turn on water supply to the refrigerator and check for leaks.
Correct any leaks.
Complete the Installation
Electdcam Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Faimureto follow these instructions can resumt in death,
fire, or electricam shock.
1. Plug into a grounded 3 prong outlet.
NOTE: Allow 24 hours to produce the first batch of ice. Discard
the first three batches of ice produced. Allow 3 days to
completely fill the ice storage bin.
Graphics are included later in this section.
Remove ancl Replace Handles
1. Using a 3/32" or 1/8" hex key, loosen the two setscrews located
on the side of each handle. See Graphics 1 and 2.
2. Pull the handle straight out from the door. Make sure you
keep the screws for reattaching the handles.
3. To replace the handles, reverse the directions.
Remove Doors and Hinges
Electrical Shock Hazard
Disconnect power before removing doors.
Failure to do so can result in death or electrical shock.
IMPORTANT.
• Remove food and any adjustable door or utility bins from
doors.
• All graphics referenced in the following instructions are
included later in this section after "Final Steps."
Loading ...
Loading ...
Loading ...