RH30WC55GS User Manual

Loading ...

99

9

Installing the hood

Mounting the duct cover bracketMounting the duct cover bracket

Mounting the duct cover bracket

The duct cover bracket should be installed against

the back wall and ush with the ceiling. This bracket

will hold the telescopic duct cover in place at the top

(this a extra accessory available not included with the

hood).

SecurSecur

Secur

e the bracket to the wall:e the bracket to the wall:

e the bracket to the wall:

tAlign the marked centerline on the bracket with

the centerline on the wall.

tMark 2 screw hole locations in the wall.

tDrill 5/16" pilot holes in the marked locations.

tInstall wall fastener anchors.

tDrive wood screws, by hand, into the fastener to

allow anchors to expand. Remove the screws.

tSecure the bracket to the wall with wood screws

and/or fasteners.

Ceiling ductingCeiling ducting

Ceiling ducting

If the duct will vent straight up to the ceiling:

tUse level to draw a line straight up, from the

centerline on the template to the ceiling.

tMeasure at least 4 -3/4 ” from the back wall to

the circle center of an 8-½” hole on the ceiling.

WW

W

all ductingall ducting

all ducting

If ductwork will vent to rear:

tUse a level to draw a line straight up from the

centerline on the template.

tMeasure at least 23 - 3/4" (the measure might

vary dependig on the elbow used) above the

pencil line that indicates the bottom installation

height, to the circle center of an 8-½” diameter

duct hole (Hole may be elongated for duct elbow).

House wiring locationHouse wiring location

House wiring location

tThe junction box is located on the top left side of

the hood.

tWiring should enter the back wall at least 20"

above the bottom of the installation height, and

within 5-7/8" and 4-7/8"of the left side of the

centerline.

Loading ...

Electrolux RH30WC55GS 30'' Chimney Wall-Mount Hood

User Manual - Page 9