Loading ...
Loading ...
Loading ...
Care and storage
60
● Steering cable ball joint (jet thrust nozzle
end) and steering cable inner wire (jet thrust
nozzle end)
EJU40933
Rustproofing
NOTICE
ECJ01360
Do not run the engine for more than 15
seconds on land without supplying water,
otherwise the engine could overheat.
Spray metallic parts of the hull and engine
with a rust inhibitor such as Yamaha Silicone
Protectant and Lubricant.
To rustproof the internal engine components:
(1) Remove the hood. (See page 28 for hood
removal and installation procedures.)
(2) Loosen the silencer cap and remove it.
(3) Make sure that the area around the wa-
tercraft is clear, and then start the engine
in a well-ventilated area.
(4) Run the engine at a fast idle.
(5) Quickly spray as much rust inhibitor as
possible through the hole in the silencer
cover. Use Yamaha Stor-Rite Engine
Fogging Oil or an equivalent. Keep spray-
ing until the engine stalls (or a maximum
of 15 seconds). WARNING! Do not pour
or spray gasoline, or any substance
other than a rust inhibitor through the
hole in the silencer cover. Do not
spray flammable rust inhibitor prod-
ucts on engine surfaces while the en-
gine is hot. Otherwise, a fire or
explosion could occur.
[EWJ00301]
(6) Securely install the silencer cap by tight-
ening it until it stops. NOTICE: Be sure to
install the silencer cap securely after
fogging the engine, otherwise water
could enter the engine and cause
damage.
[ECJ00152]
(7) Securely install the hood in its original po-
sition.
1 Silencer cap
UF2F13E0.book Page 60 Thursday, June 17, 2010 1:41 PM
Loading ...
Loading ...
Loading ...