Loading ...
Loading ...
Loading ...
5
EN
www.napoleongrills.com
N415-0437 MAY 09.18
Handle With Care
CAUTION! Use care when handling or transporng your grill to prevent damage and misalignment
of internal components. Although this grill has been designed with mobility in mind, rough handling or
abuse will result in damage to internal components, prevenng your grill from operang properly.
WARNING! The dust cap should be in place when the propane cylinder is not in use to
prevent dirt and debris from entering.
WARNING! Review instrucons on propane cylinder prior to using. A dented or rusted
cylinder may be hazardous. Discard cylinder if rust parcles or debris are in the connecon
area of the propane cylinder.
General Informaon
This gas barbecue is cered under Canadian and American Naonal Standards, CSA 1.6 - 2015 and ANSI
Z21.58 - 2015 respecvely for outdoor gas grills and should be installed to conform to local codes. In the
absence of local codes, install to the current CAN/CSA-B149.1 Propane Installaon Code in Canada or to
the Naonal Fuel Gas Code, ANSI Z223.1/NFPA 54 and ANSI/NFPA 58 in the United States.
Use only the pressure regulator provided with this barbecue. Replacement pressure regulators must be
supplied by or specied by the manufacturer. The regulator supplies a pressure of 11 inches water column
to the gas grill and has a female CGA#600 type ng.
Cylinder Installaon: 1 lb (.454kg) disposable cylinders to be used with this unit must be equipped with
a male CGA #600 type connecon. This cylinder has a posive seang connecon, which will not allow
gas ow unl a posive seal has been achieved. To install the cylinder simply screw it into the regulator
- ghten hand ght. The cylinder must be an upright posion, hanging down from the regulator when
operang the grill. This will prevent liquid propane from entering the regulator, which can cause over
ring and damage to the regulator.
WARNING! Use cylinders that are marked “Propane Fuel” only.
WARNING! Be careful not to cross thread when installing the cylinder. Do not use tools to ghten
the cylinder.
Loading ...
Loading ...
Loading ...