Loading ...
Loading ...
Loading ...
8
Operating Instructions
Operating Instructions
(continued)
CHECK FILTER FEATURE, YOU WILL SEE:
.devreser sthgir llA.cnI ,stcudorP emoH xulortcelE 9002
DO THIS:
PRESS FILTER
RESET BUTTON
TIMER: DELAY STOP / START FEATURE YOU WILL SEE HOW MUCH TIME IS CHOSEN:
FIRST
DO THIS:
PRESS
TIMER BUTTON
THEN
DO THIS:
PRESS
UP/DOWN BUTTONS
Note: This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation. The LED
(light) will illuminate after 250 hours of operation. To reset
after cleaning the filter, press the "Filter Reset" button and
the light will go off.
If the display reads "AS" , a sensor has failed. Contact your If the display reads "E7", the indoor motor has failed.
Contact your Authorized Frigidaire Service Center.Authorized Frigidaire Service Center.
FAULT CODES:
Note: For Delay Stop, the unit must be in the On position
Note: For Delay Start, the unit must be in the Off position.
First, Press TIMER button, then adjust timer setting, tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change delay
timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time
remaining until start (8, 7.5, 7, etc.). The Delay Start Operation automatically selects cooling with maximum Fan speed (if Cool,
Energy Saver, or Fan Only was the last mode selected) . The temperature maintained will be the same as previously set. To change
the set temperature, press "COOL" then Up or Down arrows until the desired temperature is indicated on the display. After 5
seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Pressing the
unit On/Off button at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either
starts or stops. Once that happens the above steps have to be repeated again.
°F
on·off fan speed sleep
ilter
reset
f
auto
hi
med
lo
°F
on·off fan speed sleep
ilter
reset
f
auto
hi
med
lo
°F
on·off fan speed sleep
ilter
reset
f
auto
hi
med
lo
hr
timer mode on·off
cool
econ
fan only
hr
timer mode on·off
cool
econ
fan only
°F
on·off fan speed sleep
ilter
reset
f
auto
hi
med
lo
Loading ...
Loading ...
Loading ...