Loading ...
Loading ...
Loading ...
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
33
ArtNo.270-0019 - Proplus tags 1
ArtNo.110-0012 Hotplate removal
9. Servicing
BEFORE SERVICING ANY GAS CARRYING
COMPONENTS TURN OFF THE GAS SUPPLY.
Check the appliance is gas sound after completion
of service. When checking for gas leaks do not use
washing up liquid – this can corrode. Use a product
specically manufactured for leak detection.
DO NOT use reconditioned or unauthorised gas
controls.
Disconnect from the electricity supply before
servicing, particularly before removing any of the
following: control panel, side panels, hotplate tray
or any electrical components or covers.
Before electrical reconnection, check that the
appliance is electrically safe.
1 Panels
1.1 To Remove the Control Panel
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Pull o all the control knobs.
Open the grill and right-hand oven doors and remove
the 4 xing screws underneath the control panel.
The control panel should drop down slightly. It is held
at the top by 2 holes in the top edge, 1 at each end, that
locate on tags on the inner panel (Fig.9-1). Clear the
control panel holes from the inner panel and pull the
control panel forward.
Disconnect the wiring from the rear.
Reassemble in the reverse order. When replacing the
leads refer to the wiring diagram. Check the operation
of the timer.
1.2 To Remove the Side Panels
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel (see 1.1). Pull the cooker
forward. Remove the 4 retaining screws for each panel
(1 at the front base, 1 on the top and 2 at the rear).
Reassemble in reverse order.
2 Hotplate
2.1 To Remove the Hotplate
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the pan supports and burner heads. Remove
the screws holding the hotplate burners to the hotplate.
Remove the 6 screws holding the hotplate tray to the
cooker (Fig.9-2).
Taking care not to damage the burner electrodes,
carefully lift the hotplate. From underneath, disconnect
the earth lead at the right-hand rear from the rear cross
member and withdraw the hotplate.
Reassemble in reverse order, making sure that you
reconnect the leads. Take care not to damage the
burner ignition electrodes.
Fig.9-1
Fig.9-2
Loading ...
Loading ...
Loading ...