Loading ...
Loading ...
Loading ...
27
ELECTRONIC CONTROL SETUP INSTRUCTIONS
Aer the dryer has been installed and plugged in,
the display will show “0 MINUTES.” Aer the door has been
opened and closed, the display will show the vend price.
This condion indicates the dryer is inoperave.
This indicates the dryer
cannot be operated. Coins dropped or debit inputs during this
condion will be stored in escrow but cannot be used unl
normal operaon is restored by opening and closing the door.
If a door switch has failed, causing “0 MINUTES” to remain
in the display aer the door is opened and closed, it must be
replaced before normal operaon can be restored.
Dryer is programmed at the
factory as follows: $1.50 dry price (30 minutes)
A few seconds aer
power is restored, if a cycle was in progress at the me of
the power failure, “RESELECT CYCLE” will ash in the display,
indicang the need for a fabric seng buon to be pressed
to restart dryer.
Aer the door is opened and then closed following
the compleon of a cycle, the display indicates the cycle price
(unless set for free operaon, where the display will ash
“SELECT CYCLE”). As coins are dropped or debit inputs arrive,
the display will change to lead the user through the iniaon
of a cycle.
A dryer setup for “Fixed Cycle” operaon can only accept
addional me accumulated by increments equal to the length
of a complete dry cycle. A maximum of 99 minutes may be
purchased; no addional credit is given for coins dropped
with 99 minutes in the display.
Accumulator Pricing
If opon d is set to d. 00, and the 6 code is set to one coin
1, then accumulator pricing is in eect. Cycle me can be
purchased one coin at a me up to the maximum me of
99 minutes.
drops or card readers only)
A dryer set to oer “Top O” capability will allow me to
be added to an exisng dry cycle in increments equal to the
number of minutes of dry me per quarter (coin 1), up to 99
minutes, regardless of the cost required to start the dryer.
No credit is given for coins or debit inputs entered when the
control is displaying 99 minutes.
Penny increment oset is not applied to top o purchases.
This is established by seng the cycle price to
zero. When this happens, “SELECT CYCLE” will appear rather
than a cycle price. Any cycle started as a free cycle
will automacally terminate when the door is opened.
DEBIT CARD READY – This dryer is debit card ready.
It will accept a variety of debit card systems, but does NOT
come with a debit card reader. Refer to the debit card reader
manufacturer for proper dryer setup. When a Generaon 2
card reader is installed, the dryer is placed in enhanced debit
mode.
In Enhanced Debit Mode, the top o price can be set
independently (see VALUE OF COIN 2), and the top o me is
calculated according to the following equaon:
In models converted to a Generaon 1 debit card system, debit
pulses represent the equivalent of one coin (coin 1).
Enhanced debit mode cannot be deselected.
Control Set-up Procedures
Read all instrucons before operang.
The fabric seng buons along with the digital display are
used to set up the dryer controls.
The display can contain 4 numbers and/or leers and a decimal
point. These are used to indicate the set-up codes and related
code values available for use in programming the dryer.
top o price
full cycle price
PRICE
top o me
full cycle length
=
Loading ...
Loading ...
Loading ...