Loading ...
Loading ...
Loading ...
18
|
SEDONA SIDE BURNER ACCESSORY CARE & USE/INSTALLATION
Installation requires an outdoor 120VAC 15A GFI (Ground
Fault Interrupter) electrical outlet adjacent to the accessory.
The GFI outlet features an internal breaker that reduces
shock hazard. This type of outlet should be installed inside
the enclosure by a qualified electrician.
The built in side burners are designed for connection to an
adjacent Lynx grill, 12-volt transformer during installation to
provide power for lighting and ignition (See INDEX: “Side
Burner Schematics”.) A Lynx LASK switch kit may be used
if no grill is available for connection. The side burners use
a standard 9-Volt battery as a back- up for the electronic
ignition system only. To install or replace the battery, follow
this procedure:
1. Locate the battery compartment
2. Using a small screwdriver, or a coin or similar object,
pry open the battery compartment and pull out the
holder
3. Remove the battery, and replace it with a fresh 9-volt
battery being careful to install the battery with the ter-
minals facing inward.
4. Insert the battery holder back into the battery compart-
ment and snap it into place
If the electrical system fails to operate, a connection may
have come loose in shipping or the GFI may have tripped,
requiring a reset. See the Troubleshooting section for
more details.
CONNECTING THE WIRING
The accessory electrical harnesses are designed to provide
power for both ignition and lighting. While ignition is con-
trolled at the accessory, lighting is controlled at the grill.
You can control lighting at the accessory by installing the
Lynx Accessory Light Switch (LASK).
Disconnect the 4-pin connector on the grill and connect
those plugs to the mating plugs on your accessory. (See
INDEX: “Electrical Connections”.)
Important note: If using multiple Lynx accessories with the
Control Illumination/Blue LED’S, a connector for this pur-
pose is built into the accessory wiring. This will allow you to
use the light switch on your Lynx grill to actuate the power
on more than one accessory.
OPTIONAL ELECTRICAL KITS
In addition to the accessory burner kits, Lynx also manufactures 3 specialized electrical kits that you may purchase for your
accessory, depending upon how it will be installed. Each electrical kit ships with an instructional sheet for assembly. As-
sembly instructions and schematics/drawings can also be found on our website at www.lynxgrills.com
.
•LASK Lynx Accessory Switch Kit
•LPEK Lynx Power Extension Kit
This switch and transformer kit allows independent control of a Lynx accessory
burner without connection to a grill. The kit contains a transformer and mounting
bracket as well as a switch assembly with a mounting plate
The Lynx Power Extension Kit provides 12 feet of additional wire between your
Lynx Grill and accessory burner.
electric connections
Loading ...
Loading ...
Loading ...