Loading ...
Loading ...
Loading ...
8 | USING THE STAND MIXER
USING THE STAND MIXER
IMPORTANT: Your Stand Mixer is adjusted at the factory so that the flat beater just
clears the bottom of the bowl. If, for any reason, the flat beater hits the bottom of
the bowl or is too far away from the bowl, you can easily correct the clearance.
NOTE: When properly adjusted, the flat beater will not strike on the bottom or sides
of the bowl. If the flat beater or the wire whip is so close that it strikes the bottom of
the bowl, coating may wear off the beater or wires on the whip may wear.
ASSEMBLING THE STAND MIXER
(OPTIONAL) To adjust beater to bowl
clearance: Tilt the motor head back;
then, using a flat-head screwdriver, turn
the screw slightly counterclockwise (left)
to raise the beater, or clockwise (right)
to lower the beater. Adjust the beater so
that it just clears the surface of the bowl.
If you overadjust the screw, the bowl
lock lever may not lock into place.
(OPTIONAL) Place the pouring shield*:
Slide the pouring shield from the front
of the Stand Mixer over the bowl
until the pouring shield is centered.
The bottom rim of the pouring shield
fits inside of the bowl. The pouring
chute will be just to the right of the
attachment hub as you face the Stand
Mixer.
5
Lower the motor head until it is all
the way down, then slide the locking
lever to the lock position. Before
mixing, test lock by attempting to
raise motor head.
*Accessory sold separately
W11118281B_ENv03.indd 8 12/22/17 11:02 AM
Loading ...
Loading ...
Loading ...