Loading ...
Loading ...
Loading ...
4
GB
-breaker with a minimum opening of 3 mm between the con-
tacts, suitable for the load indicated and complying with cur-
rent directives, must be installed between the appliance and
the mains (the earthing wire must not be interrupted by the
circuit-breaker). The power supply cable must be positioned
so that it does not exceed room temperature by 50°C at any
point of its length. Before making the connection check that:
• the limiter valve and the home system can support
appliance load (see data plate);
• the power supply system has an efficient earthing
connection which complies with the provisions of current regu-
lations and the law;
• there is easy access to the socket or the omnipolar
circuit-breaker once the cooker has been installed.
! Do not use reducers, adapters or shunts as these could cau-
se heating or burning.
Connecting the supply cable to the electricity mains
Install a standardised plug corresponding to the load
indicated on the appliance data plate (see Technical data
table).
The appliance must be directly connected to the mains using
an omnipolar switch with a minimum contact opening of 3
mm installed between the appliance and the mains. The
switch must be suitable for the charge indicated and must
comply with current electrical regulations (the earthing wire
must not be interrupted by the switch). The supply cable
must be positioned so that it does not come into contact with
temperatures higher than 50°C at any point.
Before connecting the appliance to the power supply, make
sure that:
• The appliance is earthed and the plug is compliant with the law.
• The socket can withstand the maximum power of the
appliance, which is indicated by the data plate.
• The voltage falls between the values indicated on the data
plate.
• The socket is compatible with the plug of the appliance. If
the socket is incompatible with the plug, ask an authorised
technician to replace it. Do not use extension cords or
multiple sockets.
! Once the appliance has been installed, the power supply
cable and the electrical socket must be easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced by
authorised technicians only.
! The manufacturer declines any liability should these
safety measures not be observed.
TABLE OF CHARACTERISTICS
Oven dimensions
(HxWxD)
Volume
Useful
measur ement s
relating to the
oven
compartm ent
58
Voltage and
frequenc y
ENERGY LABEL
Eco
Safety Chain
! In order to prevent ac-
cidental tipping of the
appliance, for example by
a child climbing onto the
oven door, the supplied
safety chain MUST be
installed!
The cooker is fi tted with a
safety chain to be fi xed by
means of a screw (not supplied with the cooker) to the wall
behind the appliance, at the same height as the chain is atta-
ched to the appliance.
Choose the screw and the screw anchor according to the type
of material of the wall behind the appliance. If the head of the
screw has a diameter smaller than 9mm, a washer should
be used. Concrete wall requires the screw of at least 8mm of
diameter, and 60mm of length.
Ensure that the chain is fi xed to the rear wall of the coo-
ker and to the wall, as shown in fi gure, so that after instal-
lation it is tensioned and parallel to the ground level.
Loading ...
Loading ...
Loading ...