Loading ...
Loading ...
Loading ...
11
Install Duct Covers
NOTE: Remove the film from the duct covers.
1. Assemble the upper duct covers together and install
the duct covers around the support frame. The larger
hole in the flanges of the upper duct cover must be
outside the smaller hole in the mating flange of the
other upper duct cover.
2. Secure the upper duct covers together with two
3.5 x 6.5 mm T10 screws at the top and two 2.9 x 3 mm
T10 screws at the bottom. Install 1 screw on each side
at the top and bottom of the assembled duct covers.
NOTE: For non-vented (recirculating) installation, the slotted
holes in the upper duct covers will be visible when assembled.
For vented installations, the slotted holes will be hidden down
inside the lower duct covers.
3. Slide the upper duct covers up the frame to the
ceiling and secure to the upper horizontal support
with 2 - 3.5 x 6.5 mm T10 screws.
4. Place the long end of the plastic clips (2) into the bottom
of the front lower duct cover.
5. Install the lower duct cover (front) to the range hood canopy.
Spread the lower duct cover opening slightly and position it
over the upper duct cover. Set the lower duct cover in place.
Position so the flanges of the lower duct cover set into the
flanges of the upper duct covers.
A
A
B
C
C
A. 3.5 x 6.5 mm screws (2)
B. Assembly holes (larger hole outside
of smaller hole on both sides)
C. 2.9 x 3 mm screws (2)
A
B
C
A. Top toward ceiling
B. Slots installed up for non-vented installations
C. Slots installed down for vented installations
B
C
A
D
A. 3.5 x 6.5 mm screw
B. Slotted holes (2)
C. Upper duct covers
D. Ceiling
B
A
A. Lower duct cover - (front)
B. Plastic clips (2) (long end for front placement)
A
B
D
C
A. Range hood canopy
B. Plastic clips
C. Lower duct covers
D. Upper duct covers
Loading ...
Loading ...
Loading ...