Loading ...
Loading ...
Loading ...
Open the appliance door.
Place the door panel on the top adjusting
bolts and align in the centre.
Screw the hex nuts onto the
adjusting bolts and tighten.
Use the 10 mm wrench
provided.
Close the door and check the position of the panel.
IMPORTANT
If the door has to be limited to a 90° opening angle,
it must be done before the panel is mounted onto
the appliance door. See chapter "Important Note
for Changing over Door Hinges or Limiting the
Hinges to a 90° Opening Angle" on page 24.
Position the panel support strips with the top lug in
the cut of the top attachment bracket.
Align the strips parallel to the side edge
of the panel and screw into place
with ten 4 x 14 screws.
Mount the base of the ventilation duct-
divider with two screws 4 x 19.
Click on the cover.
or
IMPORTANT
Risk of damaging
the panel.
Do not undershoot
the minimum panel
thickness (shaker
style).
20
I
nStallatIon
IMPORTANT
After a certain time
and loading, it may be
necessary to readjust the
door again.
Tx™ 15
Tx™ 15
Loading ...
Loading ...
Loading ...