Loading ...
Loading ...
Loading ...
3. When moving forward and backward/
left and right ying stick to left or right,
then the quadcopter is ying to left or
right at the same time.
4. When moving forward and backward/
left and right ying stick to front or back,
then the is ying forward or backward
at quadcopter the same time.
5. Adjust left and right rudder trim
When taking o, the body head
drifts to left,then adjusts right
rudder trim, otherwise left
rudder trim.
6. Adjust forward and backward trim
When taking o, the body drifts
forward, then adjusts backward
trim, otherwise forward trim.
7. Left & right trimmer
When taking o,the body drifts
to left, then adjusts right trim,
otherwise left trim.
High/low speed mode
This quadcopter comes with high and low speed modes,press down the high
and low speed button in the transmitter, then LCD display screen will show
switch for MODE1 and MODE2.
MODE 1 (Low speed mode, suitable for beginner)
MODE 2 (High speed mode,suitable for RC enthusiast )
1. When quadcopter is ying in the air, press down the ip button in the lower
right corner of transmitter, then the quadcopter will ip 360 degrees.
(When quadcopter bottom light gets ashing, then it's not allowed to ip)
Flip:
Press This Button
2. When quadcopter is ying in the air, then left hand press down the ip mode
switch in the upper left corner of transmitter, then transmitter will sound
"DI, DI...", it shows that quadcopter is ready to ip. Use your right hand to push
the rudder stick to utmost, then release, the quadcopter will ip 360 degrees
to forward and backward or left and right side simultaneously. Meanwhile the
ip mode will automatically shut down.
Press This Button
Warning: enough room is need for this motion, or danger may occur.
Headless mode:
Press Headless Mode button, the LED light of drone goes o. This indicates
that Headless Mode is on.
Press the Headless Mode button again, the LED light of drone turns on. This
indicates that Headless Mode is o.
NOTE: When the drone is in Headless Mode, the head of drone must face
towards the front. While in Headless Mode, if the direction and angel of
drone is oset, you can exit from Headless Mode and then turn Headless
Mode on again. This will cause the direction and angel to reset to normal
status.
Press This Button
During normal ight, the head of the drone is towards the front. Pressing the
Headless Mode button, the LED light of the drone body turns o. This indicates
that Headless Mode is activated. There is no direction to distinguish the front
and back of the drone when ying.
7 8
www.PyleUSA.com
www.PyleUSA.com
Loading ...
Loading ...