Candy PG905AMX Hobs

User Manual - Page 8

For PG905AMX.

PDF File Manual, 16 pages, Download pdf file

Loading ...
Loading ...
Loading ...
The gas feed connector is a G1/2" threaded concentric reducer. (Fig.13)
For ISO R7 connections, the gasket is not necessary.
For ISO R228 connections, the head washer provided must be inserted.
When the connection operations are finished, check the seal of the connections using a soap
solution
.
Electrical connection
The appliance must be connected to the mains power supply after verifying that the voltage corresponds to
the value indicated in the
typeplate characteristics and that the sections of the electrical system cables can
support the load indicated on the typeplate.
The plug that is used for the connection must be up to standard and suitable for the power absorbed by the
appliance. If the a
ppliance is to be connected directly to the mains, an omnipolar switch must be placed
between the appliance and the mains which has a minimum opening distance of 3 mm between the
contacts, is suitably sized for the load and satisfies the relative standards
.
Do not use reducers, adapters or shunting switches for the connection to the mains, since
these may overheat and cause burnouts.
The earthing of the appliance is mandatory. The manufacturer declines all responsibility
resulting from failure to observe this rule. (Fig. 11)
If the power cord must be replaced, use a cable having the same characteristics as that provided, suitable
for the load and temperature (type T90°C). This cable must be requested from the service centr
e. The end
that goes to the appliance must also have the Yellow
-
Green earth wire 20 mm longer than the others.
ATTENTION:
should it be necessary to replace the supply cord, connect the wire in accordance with the following
colours/codes
:
BLUE
NEUTRAL
(N)
BROWN
LIVE
(L)
YELLOW
-
GREEN
EARTH
For the power cord dimensions, see the table below:
Type of cooktop
Dimension
Only with gas burners
3 X 0.75 mm2 H05 V2V2
-F
THE MANUFACTURER DECL
INES ALL RESPONSIBILITY IF THE INSTRUCTIONS ABOVE AND
RELEVANT SAFETY STANDARDS ARE NOT OBSERVED.
CLEANING
To keep your cooktop in good condition, it should be cleaned regularly after each use once it has cooled.
Never remove the knobs from their seats
.
En
amelled parts
All enamelled parts must be washed only with a sponge and soapy water or using other non
-
abrasive
products made specifically for enamelled surfaces. After washing, dry thoroughly.
Stainless steel surface
The stainless steel surface should be cleaned with a damp cloth and specific products easily found on the
market.
After rinsing well, if possible, dry with a buckskin cloth.
Grates
The enamelled grates of the cooktop have been designed to be washed even in the dishwasher.
The stainless steel r
educer may take on a bluish colouring in the burner area due to the temperature. This
effect may be attenuated using common stainless steel sponges available on the market.
Burners
The burners, composed of two pieces, can be removed and washed with suitabl
e products. After cleaning,
they must be thoroughly dried and replaced precisely on their seats.
With regard to the electric ignition, check that the electrode E (fig.12) is always clean.
Clean the probe T (fig.12) so as to allow regular operation of the s
afety valve. Both the electrode and the
probe must be cleaned with caution. When finished, replace the burners precisely in their housing.
To prevent damage to the electric ignition, avoid using it when the
burners are not in their seats.
6
Loading ...
Loading ...
Loading ...