Loading ...
Loading ...
Loading ...
Delay start
You can delay the start of the cycle in one hour increments up to 24 hours.
• Open the door (for hidden controls only).
• Turn unit on using the [ON/OFF] button.
• Press [+] until the display jumps to “h:01”.
• Press [+] or [–] until the displayed time corresponds with your requirements. “h:01” = 1 hour delay “h:24” = 24 hour delay
• Press [
START]. Delay start is activated.
• Press the [+] or [–] button until “h:00” is indicated on the digital display.
You can change your selection at any time until the program starts.
• Close the door (for hidden controls only).
Cycle Completion Signal (hidden controls only)
The cycle completion is indicated by a tone. This function can be changed as follows:
• Open the door .
• Turn unit on using the [
ON/OFF] button.
• Hold down the “A” button (see page 4) and press [START] until the display shows “H:00”.
• Release both buttons.
• Press the “A” button until the display shows “b:02”.
• Press the “C” button to increase or decrease the tone. “b:00” = o and “b:03” = loudest
• Press [
START to save the setting.
• Close the door.
Intensive drying
The nal rinse uses a higher temperature which improves the drying result.
The running time may increase slightly. (Use caution if utensils are delicate!)
• Open the door (for hidden controls only).
• Turn unit on using the [
ON/OFF] button.
• Hold down the “A” button (see page 4) and press [START] until the display shows “H:00”.
• Release both buttons.
• Press the “A” button until the display indicates “d:00”.
• Press the “C” button to turn intensive drying on or o. “d:01” = ON or “d:00” = OFF
• Press [
START] to save the setting.
• Close the door (for hidden controls only).
Auto Power O
To save energy, the dishwasher is turned o 1 minute after the wash cycle ends. Auto Power O can be adjusted from P:00
to P:02.
To change the factory setting (P:01):
• Open the door (for hidden controls only).
• Turn unit on using the [
ON/OFF] button.
• Hold down the “A” button (see page 4) and press [START] until the display shows “H:00”.
• Release both buttons.
• Press the “A” button until the display indicates “P:01”.
• Press the “C” button to turn intensive drying on or o. “P:00” = dishwasher does not turn o automatically,
“P:01” = dishwasher turns o after 1 minute, “P:02” = dishwasher turns o after 120 minutes (2 hours)
• Press [
START] to save the setting.
• Close the door (for hidden controls only).
16
InfoLight (model dependent)
An LED illuminates the oor to indicate the unit is running. Do not open the dishwasher door until the LED is no longer visible
on the oor. If the appliance is installed at eye-level, the LED is not visible.
To change the setting:
• Turn unit on by pressing the [
ON/OFF] button.
• Hold down the “A” button (see page 4) and press [START] until the display indicates “H:00”.
• Release both buttons.
• The LED for “A” ashes and display indicates “H:04”.
• Press the “A” button until the display shows “1:01”.
• Press the “C” button to switch between “1:01”= ON and “1:00” = OFF and press [START] to save setting.
Loading ...
Loading ...
Loading ...