Loading ...
Loading ...
Loading ...
7
It is recommended that a 2.5mm gap be allowed on each side so that the cooker
may be moved if necessary.
The worktop or kitchen cabinets must not protrude beyond the height of the cooker
hotplate frame.
VENTILATION
Your appliance is not connected to a combustion products evacuation device. The room in which it is to be
installed must have an air supply in accordance with national standards. The room must have an opening
window or equivalent, and some rooms may require a permanent vent in addition to the opening window.
General guidelines: The cooker must not be installed in a bedsit room of 20m³
or less. If the cooker is
installed in a room with a volume of less than 5m³, then a vent with an effective area of 100cm³ is required.
If it is installed in a room with a volume of between 5m³
and 10m³, then an air vent with an effective area
50cm³
is necessary. If there are other fuel burning appliances in the room, please consult national standards
for guidance.
GAS CONNECTION
IMPORTANT: THIS APPLIANCE MUST BE INSTALLED BY AN AUTHORISED PERSON.
This appliance shall be installed only by authorised persons and in accordance with the manufacturer's
installation instructions, local gas fitting regulations, municipal building codes, electrical wiring regulations,
AS/NZS 5601 - Gas Installations and any other statutory
regulations.
WARNING! The appliance utilizes a threaded 1/2” BSP external thread gas cylindrical male fitting
according to UNI-ISO228-1.
Gas inlet (mm) Nat gas Gas inlet (mm) LPG
From RH rear side: 35 mm From RH rear side: 35mm
Up from floor: 590 mm Up from floor: 675 mm
Fig.3.
For ease of service, the cooker should be connected with a Flexible Hose, which complies with AS/NZS
1869 (Australian Approved), 10mm ID, class B or D, between 1 - 1.2m long and in accordance with AS/NZS
5601 for a high level connection.
WARNING: Ensure that the hose is not subjected to abrasion, kinking or permanent deformation and should
be able to be inspected along its entire length. Unions compatible with the hose fittings must be used and
connections tested for gas leaks. The fixed consumer piping outlet should be at approximately the same
height as the cooker connection point, pointing downwards and approximately 200mm - 300mm in from the
left hand side of the cooker. The hose should be clear of the floor when the cooker is in the installed position.
A hose restraint chain should be anchored to the wall to prevent strain on the hose connections when the
cooker is pulled forward.
Fit the supplied gas connectors for your installation gas type. The gas inlet has a 1/2" BSP male thread.
When making the connection, take care not to apply excessive stress by counterbalancing tightening force.
Ensure that the available gas supply is the same as the gas type label affixed near the gas connection point.
If not, contact Bertazzoni for a Gas Conversion Kit.
Loading ...
Loading ...
Loading ...