Loading ...
Loading ...
Loading ...
Sewing
24
e
Check the symbol for the presser foot shown in the
LCD or stitch pattern display window, and then attach
the appropriate presser foot. Attach zigzag foot “J” in
this procedure. (It is on the machine when purchased.)
• For details on changing the presser foot, refer to
“Replacing the Presser Foot” on page 21.
f
Set the fabric under the presser foot. Hold the fabric
and thread with your left hand, and rotate the
handwheel counterclockwise or press (Needle
position button) to set the needle in the sewing start
position.
g
Lower the presser foot lever.
h
Adjust the sewing speed with the sewing speed
controller.
You can use this controller to adjust sewing speed
during sewing.
i
Press the “Start/Stop” button to start sewing. (When
the foot controller is plugged in, slowly press down on
the foot controller.)
Guide the fabric lightly by hand.
j
Press the “Start/Stop” button again to stop sewing.
(When the foot controller is plugged in, remove your
foot from the foot controller.)
k
Press (Needle position button) to raise the needle.
l
Raise the presser foot lever, and then remove the
fabric.
m
Pull the fabric to the left side of the machine, and then
cut the threads by using the thread cutter.
n
Check the sewing finish. If necessary, adjust the thread
tension. (page 27)
■ Using the foot controller
You can also use the foot controller to start and stop
sewing.
a
Turn off the machine.
CAUTION
• Always use the appropriate presser foot. If the
wrong presser foot is used, the needle may
strike the presser foot and bend or break,
possibly resulting in injury.
Refer to “Stitch Chart” on page 33 for presser
foot recommendations.
1 Fast
2 Slow
a
b
Memo
• When the foot controller is being used, you cannot start
sewing by pressing the “Start/Stop” button.
Memo
• When the foot controller is connected, you cannot use
the “Start/Stop” button.
• Bobbin winding can be started and stopped with the
foot controller.
Loading ...
Loading ...
Loading ...