Loading ...
Loading ...
Loading ...
12
Setting up
• Avoid locating the appliance in direct sunlight or near heat
sources such as an oven or a radiator.
• The fl oor should be level and even. You can compensate for
an uneven fl oor by adjusting the adjustable feet.
• Standard EN 378 specifi es that the room in which you
install your appliance must have a volume of 1 m³ per 8 g
of R600a refrigerant used in the appliance, so as to avoid
the formation of infl ammable gas/air mixtures in the room
where the appliance is located in the event of a leak in the
refrigerant circuit, The quantity of refrigerant used in your
appliance is indicated on the type plate on the inside of the
appliance.
• The appliance is set to operate within specifi c ambient
temperature limits according to its climate rating. These
temperature limits should not be exceeded. The correct
climate rating for your appliance is indicated on the type
plate.
SN - ST = +10 ° C to +38 °C
SN – T = +10 °C to +43 °C
Switching the appliance on and off
You are recommended to clean the appliance before switching
it on for the fi rst time (see “Cleaning”). Connect the appliance
to the mains – the appliance is on.
To switch the appliance off : Keep ON/OFF button pressed •
for 3 sec. so that the temperature display goes out.
To switch the appliance on : Press the ON/OFF button until •
the Display lights up.
Operating and control elements
Temperature display
Temperature setting button
Audible warning on/off button
Interior light on/off button
Child - proof lock
On/off button
Ventilation on/off button
Setting the temperature
To reduce the temperature : Press the button.
To increase the temperature : Press the button.
While you are entering •
the temperature, the set
temperature will fl ash on
the display.
You can change the •
settings in increments of
1
o
C briefl y pressing the
button again.
The electronic controls •
will switch over automatically about 5 seconds after the
last time you pressed the button, and the actual tempera-
ture will be displayed.
If F1appears in the display, the appliance has a fault. Consult
your nearest customer service point.
Loading ...
Loading ...
Loading ...