Loading ...
Loading ...
Loading ...
33
CARE AND CLEANING
Replacing the Oven Light
Replacing the oven interior light bulb:
The interior oven light is located at the rear of the oven
cavity and covered with a glass shield. The glass shield
must be in place whenever the oven is in use (
Figure 20).
1. Turn electrical power off at the main source or unplug
the appliance.
2. Remove interior oven light shield after removing the
wire holder by carefully moving the wire to the side of
the glass shield. The tension from the wire holds the
glass shield in place.
3. Pull the shield straight out. Do not twist or turn.
4. Replace the bulb with a new appliance bulb.
5. Replace the glass oven light shield. Replace wire
holder.
6. Turn the power back on again at the main source (or
plug the appliance back in).
7. Be sure to reset the time of day on the clock.
To remove and replace storage drawer (some
models)
Use the storage drawer for storing cooking utensils. The
drawer can be removed to facilitate cleaning under the
range. Use care when handling the drawer.
To remove the drawer:
1. Open the drawer to the fully opened position.
2. Locate the latches on both sides of the drawer.
3. Pull up on the left glide latch and push down on the right
glide latch.
4. Pull the drawer away from the range.
To replace the drawer:
1. Align the glide latches on both sides of the drawer with
the slots on the drawer.
2. Push the drawer back into the range.
Be sure the oven is unplugged and all parts are cool
before replacing the oven light.
Figure 20: Oven light protected by glass shield
Do not allow your fingers to touch the new bulb when
replacing. This will shorten the life of the bulb. Use a
paper towel or cotton glove while handling the new bulb
when installing.
CAUTION
NOTE
Figure 21: Parts of storage drawer
Latch
Latch
Left Glide
Right Glide
Pull up latch
with finger
Pull down latch
with finger
Loading ...
Loading ...
Loading ...