Candy PCP700/1SDXA Hobs

User Manual - Page 5

For PCP700/1SDXA.

PDF File Manual, 7 pages, Download pdf file

Loading ...
Loading ...
Loading ...
7
ATTENTION: When cleaning the hob, take care to replace the burners correctly,
this will ensure that the ignition point is not blocked.
GENERAL ADVICE
For the best results, the flat-bottomed pans size should match the gas burner size as
follows:
— Small from 6 to 12 cm.
— Medium from 12 to 18 cm. — Large from 18 to 24 cm.
— Double ring from 24 to 28 cm. — Maxi from 24 to 28 cm.
— Fish from 26 to 28 cm.;
Rectangular pan max 210x370 - min. 150x290 mm.
For smaller containers the gas burner should be regulated so that the flame does not
overlap the base of the pan. Vessels with concave or convex base should not be used.
WARNING: If a burner is accidentally extinguehed, turn the knob to the off posi-
tion and do not attempt to re-ignite if for at least 1 minute.
To protect the glass lid from damage and in the interests of safety, the burners/plates must be
turned off and the burner/pan support/plate area must be cool before closing the lid down.
Mijorose burner: the heat diffusing plate, to be used only on the rear right hand
burner, is designed to provided a particularly delicate cooking facility. When
this facility is not required, the burner can be used in the conventional way.
Use of electric hotplates (electric hotplates)
For the best use of the electric hotplates and to minimise energy consumption, the fol-
lowing recommendations should be noted.
A neon indicator light adjacent to the control knob will glow when the electric plate is
in use.
POWER OUTPUT - ELECTRIC HOTPLATES
Setting
0 OFF
1 VERY LOW Warming dishes & melting butter and chocolate
2 LOW Simmering, sauces, stews, milk puddings, poached eggs
3 MODERATE Vegetables, frozen foods, boiling water
4 MEDIUM Fresh Vegetables, pasta, fish, pancakes.
5 HIGH Omelettes, steaks
6 VERY HIGH Chops
After the burner ignites, turn the knob to the control setting required.
The ignition is by repetitive spark generation; in case the burner does not light at once,
keep the knob in the ignition position for a maximum of 5 seconds.
If the burner does not ignite in this time, switch off the control knob and repeat the ope-
ration again.
As a safety device, some models automatically cut off the gas supply if the flame is
accidently extinguished. In this case, push and rotate the control knob until the
posi-
tion and keep it held
down for approx 5-6 seconds.
The burner will then remain lit.
MAINTENANCE AND CLEANING
Important Advice
Before cleaning the Hob, ensure the appliance has cooled down. Remove the plug from
the socket or (if connected directly) switch off the electricity supply.
When cleaning the enamelled, varnished or chrome sections, use warm soapy water
or a non caustic detergent. For stainless steel use an appropriate cleaning solution.
Hotplates should only be cleaned with a cotton cloth coated with vaseline or seed oil.
Never use abrasives, corrosive detergents, bleaching agents or acids. Avoid any acid
or alkaline substances (lemon, juice, vinegar etc.) on the enamelled, varnisched or stain-
less steel sections.
The burners can be cleaned with soapy water. To restore their original shine, use a
household stainless steel cleaner. After cleaning, dry the burners and replace.
It is important the Burners are replaced correctly.
The appliance is not intended for use by young children or infirm persons without su-
pervision. Young children should be supervised to ensure that they do not play with
the appliance.
This appliance must only be used for the purpose for which it is intended, domestic
cooking, and any other use will be considered improper and could therefore be danger-
ous. The Manufacturer will not be responisble for any damage or loss resulting from
improper use.
8
Fig. 9
YES NO NO NO NO
Only pans which have smooth flat bases should be used on the electric hotplates. The
size of the pan should be as close as possible to the diameter of the hotplate, and ne-
ver smaller (see Fig. 9). The base of the pan should be dry and spillages should be
avoided. Empty pans should not be left on the plates, nor should the plates left switched
on without a pan.
THE GAS HOBS WITH ONE ELECTRIC
PLATE ARE FITTED WITH A PAN SUP-
PORT TO BE USED FOR RESTING PNA
WHEN THE PLATE IS NOT IN USE.
WHEN THE HOTPLATE IS SWITCHED
ON THE PAN SUPPORT MUST BE LIF-
TED UP TO ALLOW THE PAN TO BE
PLACED IN DIRECT CONTACT WITH
THE HOTPLATE.
Fig. 10
Loading ...
Loading ...