Loading ...
2
TOP OF WALL SLEEVE
"A"
MINIMUM
"A"
MINIMUM
INTERNAL
A
DJACENT
WALL
INTERNAL
ADJACENT
WALL
OUTSIDE
WALL
Allow Front Clearance (see Table 1)
Figure 2 - Minimum Unit Clearances
FINISHED
FLOOR
42 1/4"
1076 mm
MINIMUM
16 1/4"
415 mm
MINIMUM
DIMENSION B"
IN TABLE 1
Figure 3 - Minimum Wall Opening Dimensions
"C" IN
TABLE 1
1/4"
6 mm
MINIMUM
"B" in
TABLE 1
CABINET
SIDE
OUTSIDE
WALL
ROOM
SIDE
CARPET OR
FINISHED FLOOR
Figure 4 - Minimum Interior and Exterior
Projections
1
If inside mounted then B = 1 1/2 inches (40 mm)
2
To achieve a flush fit between the hydronic front and the finished wall, Dimension “C” must be between 3” and
3 1/8”. If this dimension is more than 3 1/8” there will be a gap between the front and the wall. This gap could
permit occupant access to hydronic lines or other dangerous parts.
3
This dimension can be from 0” to 3-1/4”, but cannot exceed 3-1/4”. If this dimension exceeds 3-1/4”, the skirt
around the front will not reach the floor.
Table 1
Inches mm Inches mm Inches mm
Wall Sleeve Only 3 75 0 0 0 0
Subbase Kit 3 75 3 1/4 85 2 3/4 75
Leveling Legs Kit 3 75 3 75 2 50
Duct Kit 3 75 0 0 2 3/8 35
Hydronic Heat Kit 9 230 0 to 3 1/4
3
0 to 85
3
3
2
75
2
Drain Kit 3 75 0
1
0
1
00
Hardwire Kit 3 75 1 1/4 30 0 0
OPTION
MINIMUM CLEARANCES AND PROJECTIONS
MINIMUM CLEARANCES MINIMUM PROJECTION
C (Figure 4)B (Figure 3)A (Figure 2)
KIT ACCESSORIES
DRAIN KIT
An indoor/outdoor drain kit is available as an accessory
item. When a drain kit is to be installed, do so before
installing the wall sleeve in the wall. See the drain kit for
actual installation instructions. For improved drainage,
install indoor drain kit as close to wall as possible.
SUBBASE, LEVELING L EGS, MAIN D UCT, AND HYDRONIC
HEAT KITS
Installation of these kits requires drilling of mounting holes
on both sides of the wall sleeve. The minimum required
clearance distance between the wall sleeve and wall is
shown in Table 1. If the distance between wall sleeve and
wall will be at or near the minimum clearance distance,
mount these kits on the sleeve before installing the sleeve
in the wall. The kit installation instructions are included
with the accessory kits.
16 1/16"
410 mm
42"
1065 mm
16" - 24"
406mm - 610 mm
WALL RECEPTACLE
WITHIN 58" FROM
BOTTOM RIGHT SIDE CORNER
ON 203/230 VAC ONLY.
Figure 1 - Wall Sleeve Dimensions
Loading ...
Loading ...