Loading ...
Loading ...
Loading ...
Hint
For details on operating a BLUETOOTH device, refer to the operating instructions supplied with the BLUETOOTH device.
Note
The pairing mode of the speaker is released after about 5 minutes and the (BLUETOOTH) indicator flashes slowly. However, when pairing
information is not stored in the speaker, such as at the factory settings, the pairing mode is not released. If the pairing mode is released before
finishing the process, repeat from step 2.
When pairing with a BLUETOOTH device that cannot display a list of detected devices or that has no display, you may be able to pair the device
by setting both the speaker and the BLUETOOTH device to pairing mode. At this time, if a passkey besides “0000” is set on the BLUETOOTH
device, pairing cannot be done with the speaker.
Once the BLUETOOTH devices are paired, there is no need to pair them again, except in the following cases:
Pairing information has been deleted after repair, etc.
The speaker is already paired with eight devices and another device is to be paired.
The speaker can be paired with up to eight devices. If a new device is paired after eight devices have already been paired, the paired device
with the oldest connection time is replaced by the new one.
When the pairing information of the speaker has been deleted from the BLUETOOTH device.
When the speaker is initialized, all the pairing information is deleted.
The speaker can be paired with multiple devices, but can only play music from one paired device at a time.
When an audio cable is connected to the speaker’s AUDIO IN jack while the speaker and the BLUETOOTH device have been connected via
BLUETOOTH connection, sound from the BLUETOOTH-connected device is not output from the speaker (the hands-free function is available). To
listen to music from the BLUETOOTH device, disconnect the audio cable from the speaker's AUDIO IN jack.
Perform the pairing procedure on the BLUETOOTH device to detect the speaker.
When a list of detected devices appears on the display of the BLUETOOTH device, select “SRS-XB2.”
If a passkey* is required on the display of the BLUETOOTH device, enter “0000.”
3
A passkey may be called “Passcode”, “PIN code”, “PIN number” or “Password.”
*
Make the BLUETOOTH connection from the BLUETOOTH device.
When the BLUETOOTH connection is established, the
(BLUETOOTH) indicator stays lit.
If the BLUETOOTH connection is not established, repeat from step 2.
4
16
Loading ...
Loading ...
Loading ...