Loading ...
Loading ...
Loading ...
C7-100ct: Surface-Mount Installation
1) Remove the vehicle panel and check
to ensure that the mounting screw
will have adequate clearance.
2) Place the surface-mount fixture on the vehicle
panel at the desired mounting location and
mark the locations of the center mounting screw
hole and the approximate center of the left
and right semicircular cutouts (for the wires).
3) Using a 1/16-inch (1.5 mm) drill bit, drill a pilot hole
through the panel at the center screw location.
4) Using a 1/4-inch (6 mm) drill bit, drill a
hole for each of the tweeter’s wires at
the locations you marked in step 2.
5) Screw the surface-mount fixture to the vehicle
panel using the supplied #8 sheet metal screw
(hand-tighten) and #8 flat metal spring nut.
Feed a tweeter wire through each semicircular
cutout in the mounting fixture and the
1/4-inch holes you drilled in the panel.
6) To attach the tweeter to the fixture, observe the
indented locking slots on the outer edge of the
tweeter body and align these with the tabs visible
on the inside walls of the fixture. Slide the tweeter
into the fixture and secure by pressing down on
the tweeter and giving it a small clockwise turn.
7) Connect the tweeter’s wires to the wire leads from
the amplifier, observing correct polarity. Install
the protection capacitor as noted on page 5.
8) Re-install the vehicle panel, taking care to route the
new wiring so as not to interfere with any vehicle
mechanisms (window mechanisms, for example).
Diagram B:
Surface-Mount Fixture Installation
6
Loading ...
Loading ...