Loading ...
Loading ...
Loading ...
Before using for the first time
33
Con@ctivity via a direct Wi-Fi
connection (Con@ctivity3.0)
Prerequisite: Wi-Fi-enabled Miele
rangehood
If you do not have a home network, you
can establish a direct connection
between the cooktop and the
rangehood.
Manually switch the rangehood off.
Press and hold the (B*) control.
Press the (1*) control at the same
time.
* Rangehoods with sensor controls.
2 will light up constantly, and 3 will flash
on and off.
The rangehood is ready for connection
during the next two minutes.
Switch the cooktop on.
Touch the 0sensor control on any of
the numerical keybanks.
Touch and hold the0 and 7 sensor
controls on the numerical keybank at
the same time for 6seconds.
The seconds can be seen counting
down in the timer display. After the time
has elapsed, a progress light will
appear during the connection attempt.
If the connection was successful, the
code : appears in the timer display.
If the connection could not be
established, the timer display will show
the code :. Repeat the steps above.
When successfully connected, 2 and 3
will light up constantly on the
rangehood.
Quit connection mode on the
rangehood by pressing the run-on
control.
Con@ctivity has now been activated.
With a direct Wi-Fi connection, it is not
possible to connect the cooktop and
the rangehood to a home network. If
this is desired later, the direct Wi-Fi
connection between the cooktop and
the rangehood must first be reset (see
“Before using for the first time –
Con@ctivity - Resetting settings” and
in the operating and installation
instructions for the rangehood see
“Disconnecting the Wi-Fi”).
Loading ...
Loading ...
Loading ...