Loading ...
Loading ...
Loading ...
Specifications:
Enclosure Type: Sealed
Driver Type: 10W3v2-D6
Nominal Impedance: 3Ω
Cont.. Power Handling: 300 Watts
JLAudio recommends using a high quality amplifier such as the JLAudio 250/1. The diagram below shows the recommended
crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power your Stealthbox®.
Included Hardware:
2) 3/8” x 1-1/2” bolts
2) Sheet wax squares
4) flat washer
4) #8-32 Kep nuts
2) Felt pads
2) 3/8” Lock washer
2) 1/2” Aluminum spacers
4) #8-32 x 1/2” Machine screws
4) #8 x 1/2” Sheet metal screws
4)#8 x 1-1/4” Sheet metal screws
1) Metal Brace Plate
10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111
JL AUDIO 250/1
monoblock subwoofer amplifier
Amplifier Input Section
Input Sens.
Input Voltage
Low/High
Left Ch.
Right Ch.
Signal Sensing
Off/On
Output Mode
Full-Range/Low-Pass/High-Pass
Left Ch.
Right Ch.
Amp LP Filter
Mode/Slope
Off/12dB/24dB
Filter Freq. (Hz)
Bass Control
LF Boost (dB)
Off/30Hz
Infrasonic Filter
+1
+13
+3
+7
+10
Preamp Output Section
+12VDC Ground Remote
The JLAudio 250/1 is a very versatile audio component. Please consult the owner’s manual for detailed information
about installing and tuning this amplifier.
➔➔➔
STEP 28: Position the OEM console shell over the
Stealthbox.
*Make sure that the aluminum spacers from
STEP 27, do not move from their location.*
STEP 32: Place the supplied pair of felt pads
between the lid and the console shell.This is going
to prevent vibration contact of console storage lid
and console shell.
➔
SB-F-SUPRCNSL/10W3V2, JL AUDIO, Inc 2005
Sheet SKU#011149 Revision 8/4/2005 Page 4
www.jlaudio.com
Mid/High Frequency Driver Information:
CONGRATULATIONS!
INSTALL COMPLETE.
XR570-Csi
TR570-Cxi
Front Location Driver Size:
5”x7”
Applicable JL Audio Products:
TR,VR, XR ZR570-Csi
Rear Location Driver Size:
5”x7”
Applicable JL Audio Products:
TR, XR570-Cxi
Cont..
From
Previous
Page
STEP 29: Insert the pair of supplied #8 screws
through the hinge holes (STEP 11) and into the
Stealthbox.
STEP 30: Reinstall the remaining supplied screws
that attach the console shell to the Stealthbox.
These screws were removed in STEP 12.
STEP 31: Replace the front tray.
Difficulty Scale