Loading ...
Loading ...
Loading ...
12
9
10
Avoid pinching
the wires
7
101
82
129
60
64
Grease
58
4
110
101
111, 146
10. See step 6. Tighten the four M10 x 25mm
Screws (92).
Untie and discard the wire tie on the Main
Wire (110).
While a second person holds the Console (7)
near the Upright (4), connect the wires on the
Console to the Main Wire (110) and to the
Extension Wires (111, 146).
Insert the excess wire into the Upright (4).
Tip: Avoid pinching the wires. Attach the
Console (7) to the Upright (4) with four
M4 x 16mm Screws (101); start all the Screws,
and then tighten them.
92
92
82
129
9. Apply grease to one of the Pedal Arm Axles (64).
Next, slide an M8 x 22mm Washer (129) onto an
M8 x 12mm Screw (82), and tighten the Screw a
few turns into the Pedal Arm Axle (64).
While a second person holds the front end of the
Right Pedal Arm (58) inside the bracket on the
Right Upper Body Leg (60), insert the Pedal Arm
Axle (64) into both parts.
Next, slide an M8 x 22mm Washer (129) onto
another M8 x 12mm Screw (82), and tighten the
Screw a few turns into the Pedal Arm Axle (64).
Then, tighten both Screws at the same time.
Repeat this step on the other side of the
elliptical.
Loading ...
Loading ...
Loading ...