Loading ...
Loading ...
Loading ...
17
GB
G:\_Upload\4082180131\4082180131SDMM81AEP\02GB-SDMM81AEP\01GB02BAS-AEP.fm
masterpage:Right
SDM-M81
4-082-180-13(1)
Technical Features
Power saving function
This monitor meets the power-saving guidelines set by VESA,
E
NERGY
S
TAR, and NUTEK. If the monitor is connected to a
computer or video graphics board that is DPMS (Display Power
Management Signaling) compliant, themonitor will automatically
reduce power consumption as shown below.
* When your computer enters the “active off” mode, the input signal is
cut and NOINPUT SIGNAL appears onthe screen. After 20 seconds,
the monitor enters the power saving mode.
** “Deep sleep” is a power saving mode defined by the Environmental
Protection Agency.
Automatic picture quality
adjustment function
When the monitor receives an input signal, it automatically
matches the signal to one ofthe factory preset modes stored in the
monitor’s memory to provide a high quality picture at the center
of the screen. (See the Appendix for a list of the factory preset
modes.)
For input signals that do not match one of the factory preset
modes, the automatic picture quality adjustment function of this
monitor automatically adjusts the picture position, phase, and
pitch, and ensures that a clear picture appears on the screen for
any timing withinthe monitor’sfrequency range(horizontal: 28 –
92 kHz, vertical: 48 – 85 Hz).
Consequently, the first time the monitor receives input signals
that do not match one of the factory preset modes, the monitor
may take a longer time than normal for displaying the picture on
the screen. This adjustment data is automatically stored in
memory so that next time, the monitor will function in the same
way as when the monitor receives the signals that match one of
the factory preset modes.
In all modes mentioned above, if the picture is adjusted, the
adjustment data is stored as a user mode and automatically
recalled whenever the same input signal is received.
Note
While the automatic picture quality adjustment function is activated, only
the
1
(power) switch will operate.
Power mode Power consumption
1
(power)
indicator
normal
operation
50 W (max.) green
active off*
(deep sleep)**
3 W (max.) orange /
green and orange
alternate
power off 3 W (max.) off
01GB01COV-AEP.book Page 17 Friday, April 20, 2001 10:55 AM
Loading ...
Loading ...
Loading ...