Sony VPL-HS1 Cineza Lcd Front Projector

User Manual - Page 34

For VPL-HS1.

PDF File Manual, 152 pages, Read Online | Download pdf file

VPL-HS1 photo
Loading ...
Loading ...
Loading ...
GB
34
Troubleshooting
Others
Others
This section describes how to solve the problems, how to
replace a lamp and air filter, etc.
Troubleshooting
Symptom Cause and Remedy
The power is not turned on. The power has been turned off and on with the [/ 1 (on/standby) switch at a
short interval.
c Wait for about one minute before turning on the power (1 page 15).
The lamp cover is detached.
c Close the lamp cover securely (1 page 38).
The air filter cover is detached.
c Close the air filter cover securely (1 page 39).
No picture. Cable is disconnected or the connections are wrong.
c Check that the proper connections have been made (1 pages 8 and 9).
Input selection is incorrect.
c Select the input source correctly using the INPUT button (1 page 15).
The computer signal is not set to output to an external monitor.
c Set the computer signal to output to an external monitor.
The computer signal is set to output to both the LCD of the computer and
external monitor.
c Set the computer signal to output only to the external monitor.
The picture from the PJ MULTI
connector is colored strange.
Setting for INPUT-A in the SET SETTING menu is incorrect.
c Select COMPUTER, COMPONENT or VIDEO GBR for INPUT-A in the
SET SETTING menu according to the input signal (1 page 20).
Color balance is incorrect. Picture has not been adjusted properly.
c Adjust the picture in the PICTURE CTRL menu (1 page 19).
Projector is set to wrong color system.
c Set COLOR SYS in the PICTURE CTRL menu to match the color
system being input (1 page 19).
The picture is too dark. Contrast or brightness has not been adjusted properly.
c Adjust the contrast or brightness in the PICTURE CTRL menu properly
(1 page 19).
The picture is not clear. Picture is out of focus.
c Adjust the focus with the focus lever (1 page 15).
The lens cap is attached to the lens.
c Remove the lens cap.
Condensation has occurred on the lens.
c Leave the projector for about two hours with the power on.
Loading ...
Loading ...
Loading ...