Loading ...
Loading ...
Loading ...
Interior equipment 6-13
6
– CONTINUED –
To extend the cover, pull the end of the
cover out of the housing, then insert its
hooks into the catches as shown. To re-
wind it, unhook it from the catches and it
will rewind automatically. You should hold
on to the cover and guide it back into the
cover housing while it is rewinding.
N
O
TE
When the head restraint is adjusted at
the rearmost position of the seat with
the seatback leaned back, the head re-
straint comes in contact with the cargo
area cover. In this case, raise the seat-
back before adjusting the head re-
straint.
If the head restraint is correctly fixed in
any of the lock positions, the head re-
straint does not contact the cargo area
cover even when the seatback is re-
clined.
To remove the cover
1. Rewind the cover.
2. Pull either sleeve on the end of the cov-
er housing to shorten the cover’s length.
3. Take it off the retainer.
Do not place anything on the ex-
tended cover. Putting excessive
weight on the extended cover can
break it and an object on the cover
could tumble forward in the event of
a sudden stop or collision. This
could cause serious injury.
600601
y If the cargo area cover is
equipped, be careful not to pinch
your hand between the headrest
and the cargo area cover when
you recline the rear seat.
y Be careful not to scratch the rear
gate stays while extending and re-
winding the cover.
Scratches on the stays could
cause leakage of gas from the
stays, which may result in their in-
ability to hold the rear gate open.
600602
A3120BE-B.book 13 ページ ２００６年５月３０日 火曜日 午前９時３２分
Loading ...
Loading ...
Loading ...