Loading ...
Loading ...
Loading ...
5-19
5
– CONTINUED –
road or inside of a parking garage.
To help reduce this condition, satellite ra-
dio providers have installed ground-based
repeaters in heavily populated areas.
However, you may still experience recep-
tion problems in some areas.
V Band selection button
Push the “SAT” button (1) when the radio
is off to turn on the radio.
Push the “SAT” button when the radio is
on to select SAT1, SAT2 or SAT3 recep-
tion.
V Channel selection
Press “ ” of the TUNE TRACK button
(4) to select the next channel and press
“ ” of the button to select the previous
channel.
Keep pressing “ ” of the button to
change to the next channel continuously
and keep pressing “ ” of the button to
change to the previous channel continu-
ously.
V Category selection
Press “ ” or “ ” of the SEEK FLDR
button (7) to display the current category.
Press “ ” again to select the next cate-
gory, and press “ ” again to select the
previous category.
V Channel scan
Press the “SCAN” button (8) to change the
radio to the SCAN mode. In this mode, the
radio scans through the channels until a
station is found. The radio will stop at the
station for five seconds while displaying
the channel number, after which scanning
will continue until the entire channel has
been scanned from the low end to the high
end.
Also during the category selection, chan-
nel scan can be performed in that catego-
ry.
Press the “SCAN” button again to cancel
the SCAN mode and to stop on any dis-
played channel.
V Selecting preset channels
Presetting a channel with a preset button
(10) allows you to select that channel in a
single operation. Up to six, SAT1, SAT2
and SAT3 channels each may be preset.
V How to preset channels
1. Press the “SAT” button (1) to select
SAT1, SAT2 and SAT3 reception.
2. Press the “SCAN” button (8) or the
TUNE TRACK button (4) to select the
channel.
3. Press one of the preset buttons (10) for
more than 1.5 seconds to store the chan-
nel. If the button is pressed for less than
1.5 seconds, the preceding selection will
remain in memory.
NOTE
If the connection between the radio
and battery is broken for any reason
such as vehicle maintenance or radio
removal, all channels stored in the pre-
set buttons are cleared. If this occurs,
it is necessary to reset the preset but-
tons.
V Display selection
Press the “AUDIO” (5) button while receiv-
ing satellite radio to change the display as
follows:
T Rear seat entertainment
If your vehicle is equipped with a Rear
Seat Entertainment System, you can en-
joy audio outputs from the system through
the vehicle’s speakers by pressing the
“RSE AUX” button. Press the button again
to return to the audio set sound.
CHANNEL
CATEGORY
TITLE
NAME
A3120BE-B.book 19 ページ ２００６年５月３０日 火曜日 午前９時３２分
Loading ...
Loading ...
Loading ...