Loading ...
Loading ...
Loading ...
5EN
English
2 Get started
Note
Before using the headphones for the rst time, charge the supplied •
batteries for at least 10 hours.
• Only use Philips rechargeable shortened sleeve NiMH batteries with your
headphones. Other types of rechargeable batteries cannot be charged
with this system.
• AAA alkaline batteries can be used to operate the headphones, but
cannot be charged with this system.
If the volume of the audio source is insufcient, the transmitter •
automatically turns off.
1 Install/Replace supplied batteries (Fig. B).
2 Install the antenna tube into the transmitter (Fig. C).
3 Power on the transmitter (Fig. D).
Red LED is on when audio source is connected. »
Red LED blinks if no audio source is connected for two »
minutes.
Red LED is off if no audio source is connected for four »
minutes.
4 To charge the headphones, connect the charging cable with
the headphones (Fig. E).
Headphones: red LED is off during charge. »
Transmitter: green LED is on during charge and is off when »
headphones are fully charged.
When one headphone is during charge, another one can still
be used.
Transmitter: both red and green LED are on. »
5 Power on the headphones and red LED is on (Fig. F).
6 Connect the audio device with the transmitter (Fig. G).
Red LED is on when audio source is connected. »
Tip
If there is interference, tune the transmitter and the headphones to the •
same channel (Fig. H).
Loading ...
Loading ...