Loading ...
Loading ...
Loading ...
5
Installing the Beverage Cooler
The beverage cooler should be installed in accordance with local
electrical code requirements. The beverage cooler should also be placed
in a location that is strong enough to support its total weight, keeping in
mind that it will weigh substantially more when fully loaded than when
empty.
Before you plug the beverage cooler into a power supply, be sure to let it
stand upright for at least 24 hours to allow the compressor’s oils to settle.
Unpacking the Beverage Cooler
WARNING: Use two or more people to move and install the beverage
cooler. Failure to do so can result in back or other injury. Carefully remove
the packaging materials. Remove any shipping tape and glue from your
beverage cooler before using. Do not use sharp instruments, rubbing
alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.
These products can damage the surface of your beverage cooler.
IMPORTANT: Do not remove any safety, warning, or product information
labels from your beverage cooler.
Types of Installation
This beverage cooler has been designed for freestanding installation and
should not be recessed or built-in. There must be adequate ventilation
and access for service.
Freestanding installation:
A freestanding installation will allow you to install the beverage cooler in
almost any place you desire. However, the unit does need an open
environment in order to vent properly. You must follow the stated
instructions for electrical requirements, and leveling the beverage cooler.
When installing the beverage cooler follow the recommended spacing
dimensions shown.
• To ensure proper service access and ventilation, allow at least 5”
clearance at the back and 4” clearance on each side. The installation
should allow the unit to be pulled forward for servicing, if necessary.
• The beverage cooler should be installed on a firm and level surface that
will be able to support the entire weight of a fully loaded unit. It is
important for the beverage cooler to be level in order to work properly. If
needed, you can adjust the height of the beverage cooler by rotating the
feet. See the “Leveling the Beverage cooler” section.
• A standard electrical supply (115 VAC only, 60 Hz), properly grounded
in accordance with National Electrical Code and local codes and
ordinances is required.
Important Notes:
• Choose a location that has
ambient temperatures above
60°F and below 90°F.
Operation outside these
temperatures may result in
lowered efficiency or cause
other adverse effects.
• This unit MUST be installed
in an area protected from the
elements, e.g., wind, rain,
water spray or drips.
• The beverage cooler should
not be located next to ovens,
grills or other high heat
sources.
• Do not kink or pinch the
power supply cord between
the beverage cooler and wall.
Loading ...
Loading ...
Loading ...