Loading ...
Loading ...
Loading ...
8
Step 3: Place the shut-off servo
B. Position the center of the servo motor over the center of the shut-off valve
Carefully place the servo and brackets over your shut-off valve and inlet pipe as
shown here. Close the brackets over your inlet pipe.
Position the servo over your shut-off valve so that the center of the servo’s motor
is directly over the center of your hot water heater’s shut-off valve as shown. The
servo’s centering ring should t over the shut-off valve’s nut (see the section on
the next page).
IMPORTANT: Keep the centers of the the servo motor and shut-off valve aligned
throughout the installation and make sure they’re aligned when you’re nished.
Servo
motor
Shut-off
valve
A. Turn your hot water heater’s shut-off valve on and off several times.
Depending on how long it’s been since the shut-off valve was last used, there
might be signicant build-up (like mineral deposits) around the valve and handle,
which makes the valve more difcult to close. Opening and closing the valve
loosens this build-up and makes the valve easier to open and close.
IMPORTANT: Leave the shut-off valve in its open position when you’ve nished
opening it and closing it.
Loading ...
Loading ...
Loading ...