Loading ...
Loading ...
Loading ...
Black plate (99,1)
北米Model "A8130BE-B" EDITED: 2007/ 7/ 25
5. While still holding down the “UNLOCK”
side of the power door locking switch,
close the driver’s door once within 10
seconds after Step 4.
6. The turn signal lights flashes 3 times to
indicate completion of the setting.
NOTE
If you do not close the driver’s door
within 10 seconds after Step 4, a flash
of the turn signal lights will signal time-
out. If this happens, repeat the whole
procedure from Step 1.
You may have the above settings done by
your SUBARU dealer.
& Replacing the battery
CAUTION
. Do not let dust, oil or water get on
or in the transmitter when repla-
cing the battery.
. Be careful not to damage the
printed circuit board in the trans-
mitter when replacing the battery.
When the transmitter battery begins to get
weak, transmitter range will begin to
decrease. Replace the battery as soon
as possible.
To replace the battery:
1. Open the transmitter case using a flat-
head screwdriver.
2. Separate the case.
3. Remove the old battery from the
holder.
1) Negative (−) side facing up
4. Replace wi th a new battery (Type
CR2025 or equivalent) making sure to
install the new battery with the negative
(−) side facing up.
5. Reinstall the back half of the transmit-
ter case by snapping it back on.
After the battery is replaced, the trans-
mitter must be synchronized with the
keyless entry system’s control unit.
Press either the “
” or “ ” button 6
times to synchronize the unit.
& Replacing lost transmitters
If you lose a transmitter or want to
purchase additional transmitters (up to
four can be programmed), you should re-
program all of your transmitters for secur-
Keys and doors 2-9
– CONTINUED –
2
Loading ...
Loading ...
Loading ...