Loading ...
Loading ...
Loading ...
Black plate (105,1)
北米Model "A8130BE-B" EDITED: 2007/ 7/ 25
. The 30-second standby time can be
eliminated if you prefer. Have it per-
formed by your SUBARU dealer.
. The system is in the standby mode
for a 30-second period after locking the
doors with the remote transmitter. The
security indicator light will flash at
short intervals during this period.
. If any of the following actions is
done during the standby period, the
system will not switch to the surveil-
lance state.
. Doors are unlocked using the
remote transmitter.
. Any door or the rear gate is
opened.
. Ignition switch is turned to the
“ON” position.
. The engine does not start even
when the ignition switch is turned to
the “START ” position once the alarm
system has been triggered.
& Disarming the system
Briefly press the “ ” button (for less than
2 seconds) on the remote transmitter. The
driver’s door will unlock, an electronic
chirp will sound twice, the turn signal
lights will flash twice and the indicator
light will go off.
NOTE (Models with immobilizer)
If your vehicle is equipped with an
immobilizer, the immobilizer’s function
will cause the security indicator light to
flash (approximately once every 3
seconds) even after the system is
disarmed.
NOTE
The system can be disarmed by the
following method, too.
. Cycle the ignition switch from the
“LOCK” to the “ON” position 3 times
within 5 seconds.
! Emergency disarming
If you cannot disarm the system using the
transmitter (i.e. the transmitter is lost,
broken or the transmitter battery is too
weak), you can disarm the system without
using the transmitter.
1. Unlock the door with the key and then
open the door.
2. Insert the key into the ignition switch
and cycle it from the “LOCK” to the “ON”
position 3 times within 5 seconds.
& Valet mode
When you choose the valet mode, the
security system does not operate. In valet
mode, the remote transmitter is used only
for locking and unlocking the doors and
rear gate and panic activation.
To enter the valet mode, change the
setting of your vehicle’s alarm system for
deactivation mode. (Refer to “Activating
and deactivating the alarm system” in this
section.) The security indicator light will
continue to flash once every 3 seconds
indicating that the system is in the valet
mode (only vehicle with an immobilizer).
To exit valet mode, change the setting of
your vehicle’s alarm system for activation
mode. (Refer to “Activating and deactivat-
ing the alarm system” in this section.)
NOTE
If your vehicle is not equipped with an
immobilizer, the security indicator light
does not flash during the valet mode.
& Passive arming
When passive arming mode has been
programmed by the dealer, arming of the
system is automatically accomplished
without using the remote transmitter. Note
that in this mode, DOORS MUST BE
MANUALLY LOCKED.
! To enter the passive mode
If you wish to program the passive arming
mode, have it done by your SUBARU
Keys and doors 2-15
– CONTINUED –
2
Loading ...
Loading ...
Loading ...