Loading ...
Loading ...
Loading ...
Installation Instructions
INSTALLING THE ANTI-TIP
DEVICE
Mark the wall where the RIGHT EDGE of
the range is to be located. Be sure to allow
for the countertop overhang if you intend to
install the range next to cabinets.
Locate the outside edge of the device 2
1
⁄8 ″
toward the center of the range from the
marked edge of the range.
Using the device as a template, mark the
position of the hole for the screw.
For wood construction, drill a pilot hole at
an angle of 20 degrees from the horizontal.
A nail or awl may be used if a drill is not
available.
Mount the Anti-Tip device with the screw
provided.
For cement or concrete construction, you
will need a 1/4″ x 1
1
⁄2″ lag bolt and a 1/2″ O.D.
sleeve anchor, which are not provided. Drill the
recommended size hole for the hardware.
D
C
B
A
10
INSTALLING THE ANTI-TIP
DEVICE
(CONT.)
Install the sleeve anchor into the drilled hole
and then install the lag bolt through the device.
The bolt must be properly tightened as
recommended for the hardware.
Slide the range against the wall, and
check for proper installation by grasping
the front edge of the cooktop and carefully
attempting to tilt the range forward.
E
10
WHEN ALL HOOKUPS ARE
COMPLETED
Make sure all controls are left in the off
position. Make sure the flow of combustion
and ventilation air to the range is unobstructed.
WARNING!
• Range must be secured with an approved
Anti-Tip device.
• Unless properly installed, the range could be
tipped by you or a child standing, sitting or
leaning on an open door.
• After installing the Anti-Tip device, verify that
it is in place by carefully attempting to tilt the
range forward.
• This range has been designed to meet all
recognized industry tip standards for all
normal conditions.
• The use of this device does not preclude
tipping of the range when not properly
installed.
• If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB2X7909.
Anti-Tip
device
Slotted head
screw
Wallplate
Approx.
20°
2
1
⁄
8”
Marked edge of range
CONVERTING TO LP GAS (or
converting back to natural gas from LP)
This range leaves the factory set for use with
natural gas. If you want to convert to LP gas,
the conversion must be performed by a
qualified LP gas installer.
The conversion instructions and LP orifices can
be found attached to the range next to the
pressure regulator.
Keep these instructions and the orifices in case
you want to convert back to natural gas.
Back of range
Wallboard
Wood screw
Anti-Tip
device
38
Loading ...
Loading ...
Loading ...