Loading ...
Loading ...
Loading ...
4) Run the Wizard
In the world of R/C, there is little standardization between equipment manufacturers as far as control
stick to channel mapping. There is also little agreement between users as to which of the 4 control
modes should be used.
Since in the Vortex, both the OSD, and the Flight Controller need to know the channel mappings, a ‘Tx
Setup Wizard’ is included to greatly simplify the process.
This wizard also configures various flight controller parameters which would normally require a personal
computer, with a USB connection to the quad copter.
NOTE: The wizard should allow a brand-new, unconfigured Vortex, to be removed from its
shipping box at a race event, and prepared for flight in less than a minute, with no tools, or USB
hookups required.
For the techies, there is a full description of the configuration steps performed near the end of the full
user’s manual, under ‘Appendix A: The Wizard - Details’.
The first time the Vortex is powered up, the Tx Setup Wizard is presented, as shown after the mode
1/mode 2 control descriptions below.
Following the instructions on-screen, 5 simple steps, will configure the 4 flight channels, and one
auxiliary control (CH5) which will control the flight mode.
9
Loading ...
Loading ...
Loading ...