Loading ...
Loading ...
Loading ...
NOTE: To restart the wizard at
anytime, power up the quad,
press and hold the button on the
led board until vortex beeps 2
times (first beep after ~3
seconds, second beep after ~5
seconds). Alternatively you can
also enter tx Wizard via OSD
menu
Once the wizard is finished,
various Cleanflight settings will
be configured, including
enabling oneshot, motor_stop,
and failsafe.
Another setting which is automatically made is the assignment of CH5 to the flight mode, Acro, Horiz,
and Angle. To complete the setup, configure your R/C Tx to link CH5 to a 3-position switch.
Ensure that the switch correctly switches between the three flight modes, reflected in the top-right corner
of the OSD main landscape .
Note that It is highly recommended to attempt the maiden flight in either Angle, or Horiz mode. Acro
takes a little getting used to.
NOTE: Even though the flight controller failsafe has been set by the wizard, it is important to also
set the R/C Rx failsafe.
see https://github.com/cleanflight/cleanflight/blob/master/docs/Failsafe.md for cleanflight specific
failsafe test procedure.
On the EzUHF this is as easy as setting the controls in a ‘safe’ position (very low throttle for
example) and holding down the bind button on the EzUHF Tx until a beep is heard.
Flyaways with mini-quads are almost always caused by incorrect failsafe settings!
NOTE: Currently there is no ‘servo reverse’ feature in Cleanflight. This means that if one of the
R/C transmitter channels is reversed, the wizard will not complete correctly.
It is highly recommended to start the wizard with a ‘new’ profile in the R/C radio, without any
channel reversing, and also without any expo. Expo is all handled within the Pro-Tuning profiles.
12
Loading ...
Loading ...
Loading ...