Loading ...
Loading ...
02 GB
INSTALLATION
Installation have to be made by qualified personnel. The manufacturer
have no obligation to carry this out. If the assistance of the
manufacturer is required to rectify faults arising from incorrect
installation, this assistance is not covered by the guarantee.
The installation instructions for professionally qualified personnel
must be followed. Incorrect
installation may cause harm or injury to
people, animals or belongings. The manufacturer cannot be held
responsible for such harm or injury.
WARNING! Care must be taken regarding where the appliance is
placed! It can only be installed in a continuously ventilated room.
Electrical connections must always be disconnected before any
repair,
installation or modification.
•Before positioning your appliance, check the properties of the energy
supply (gas type, gas pressure) and make sure that your appliance is
regulated accordingly.
•This appliance must not be connected to the exhaust system of any
equipment running on other fuel.
•The appliance must not be installed near flammable
materials (e.g.
furniture, curtains, etc.)
•This grill(s) should be constructed so that it cannot be closed from
either side and positioned preferably near the floor. Grill(s) must not
be placed across the channels through which combustion gases and
exhausted fumes pass.
•If it is impossible to install grilled air vents
in the room where the
appliance is installed, the air needed can also be supplied from an
adjacent room providing it is not a bedroom or a room where an air
current could cause danger.
ENVIRONMENT THE APPLIANCE SHOULD BE
PLACED
•There must be sufficient natural air ventilation in the room for gas
combustion for the appliance to function correctly.
•The air flow should enter through grilled air vents in the outer walls.
•Air grills must have a cross section of 100 cm² for the passage of air
and for appliances with
a flame safety device. For appliances with no
flame safety device, this cross section should be 200 cm². (Single or
multiple grills can be used)
Emission of Combustion Gases
•Combustion gases from cooking appliances must be released
directly out of doors or via a hood connected to a chimney or flue
(Figure 1)
•If it is impossible to install a hood, an electric extraction fan should be
fitted in a wall or a window opening out of doors (Figure 2)
•Extractor fans should have a capacity of replacing kitchen air 3-5
times per hour.
Figure 1 Figure 2
POSITIONING
This appliance is of the "X" type and it has been designed on the
presumption that the adjacent work tops will be no higher than the
cook top surface.
This appliance is class 2.1
FEET ADJUSTMENT
Your appliance has adjustable feet at the
lower corners of its chassis.
The feet can be adjusted individually with
the aid of a wrench to guarantee that the
oven is perfectly balanced and level, so
that any liquids in the pans is horizontal .
750 mm
20 mm 20 mm
400 mm
200 mm 200 mm
Loading ...
Loading ...
Loading ...