Loading ...
Loading ...
Loading ...
(Not found on all clipper models.) To adjust power, turn power screw in clockwise direction
until clipper makes a noise caused by the armature hitting the coil. Then, slowly turn power
screw out (counter-clock-wise) just until noise stops. This is maximum power.
WARNING
If this appliance is fitted with a BSI 1363 13 Amp British plug, and the molded plug fitted to this
item is not suitable for your socket outlet, it should be CUT OFF AND DESTROYED.
Important wiring instructions: The wires in the mains lead are colored in accordance with the
following code: BLUE - NEUTRAL BROWN - LIVE.
As the colors of the wires in the mains lead of this appliance may not correspond with the
colored markings identifying the terminals i your plug, proceed as follows:
The wire which is colored blue must be connected to the terminal which is marked with the letter
N or colored black.
The wire which is colored brown must be connected to the terminal which is marked with the
letter L or colored red.
If a 13 amp (BS 1363) plug is used, a 3 amp fuse must be fitted, or if any other type of plug is
used , a 5 amp fuse must be fitted either in the plug or adapter at the distribution
board. Replacement fuses should be ASTA approved to BS 1362.
Fuse cover must be refitted when changing the fuse. If fuse cover is lost, the plug must not be
used until a replacement is obtained. Information for obtaining the correct fuse carrier is marked
on the carrier itself and in the bottom of the fuse cavity on the plug. These may be obtained from
Wahl.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.