Loading ...
Loading ...
4. Clattering when turning the clipper on or off may occur on some clippers. It is of no
consequence. The same is true if your clipper heats up after 20-25 minutes of use.
5. Make sure cord is not twisted or kinked while unit is charging or being stored.
6. To clean the unit, use either a clean, dry or dampened cloth. Do not use benzene or thinner to
clean the unit.
On the Wahl Clipper
The bottom blade holes are larger than the shanks of the blade screws. When the blade screws
are loosened the bottom blade can be aligned with the top blade. Keep the screws tight after the
blade is aligned.
1. End of top blade teeth should be 1/32" to 1/16", .79 mm to 1.59 mm back from bottom
blade. This is important so that the clipper doesn't cut too close or allow the moving cutter to
touch the skin.
2. Extreme left hand tooth of top blade must be covering or be to the left of the first small tooth
of bottom blade.
3. Extreme right hand tooth of top blade must be touching the big tooth on the bottom blade.
On Clippers Using "Adjusto-Lock" Blades
To remove the blades loosen only center screw. Leave the two outside screws tight as they hold
bushings in place to keep alignment of blades. Keep screws tight wehn in operation.
CORD
If your clipper has a polarized plug:
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than
the or other). This plug fits in a polarized outlet only one way. In the event the plug does not fit
fully in the outlet, reverse the plug. In the event it still does not fit, contact a qualified electrician
to install the proper outlet. Do not change the plug in any way.
TAPER LEVER
Some clippers are equipped with an adjustable taper lever that changes the closeness of your
cut. When the lever is in the uppermost position, the blades will give the closest cut. Pulling the
lever downward gradually increases the cutting length.
POWER SCREW
Loading ...