Loading ...
Loading ...
Loading ...
Installation
1.
Attach the side collars to the wheel.
2.
On the right side, place the wheel
between the fork legs and insert the front
axle shaft, through the right fork leg and
wheel hub.
u Avoid scratching the brake pads,
carefully fit the brake disc between the
pads.
NOTICE
When installing a wheel or caliper into original
position, carefully fit the brake disc between the
pads to avoid scratching them.
3.
Tighten the axle shaft.
Torque: 51 lbf·ft (69 N·m, 7.0 kgf·m)
4.
Lower the front wheel on the ground.
5.
Apply the brake lever several times. Then,
pump the fork several times.
6.
Tighten the axle pinch bolt.
Torque: 16 lbf·ft (22 N·m, 2.2 kgf·m)
7.
Raise the front wheel off the ground
again, and check that the wheel rotates
freely after you release the brake.
8.
Lower the front wheel on the ground
again.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
20161109162147_31KZZA400_enu_BOOK Page 95 Wednesday, November 09 2016 16:25:27 JST
Tire Puncture u Removing Wheels
Troubleshooting
92
Loading ...
Loading ...
Loading ...