Loading ...
Loading ...
Loading ...
Water softening system en
29
Note:Set the water hardness determ-
ined on your appliance.
→"Setting water softening system",
Page29
With a water hardness of 0 - 8°E you
can dispense with special salt and
switch off the water softening system.
→"Switching off water softening sys-
tem", Page30
Setting water softening sys-
tem
Set the water hardness on your appli-
ance.
1. Determine the water hardness and
the appropriate setting value.
→"Overview of water hardness set-
tings", Page28
2.
Press .
3. Hold programme button A and press
repeatedly until the display
shows H:xx.
4. Release programme button A and
.
a Programme button A flashes and the
display shows H:04.
5. Press programme button C re-
peatedly until the right water hard-
ness has been set.
6.
Press to save the setting.
Special salt
You can use special salt to soften wa-
ter.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser
for special salt just before the pro-
gramme starts. The amount of special
salt required depends on the water
hardness: the higher the water hard-
ness, the greater the amount of special
salt required.
ATTENTION!
¡ Detergent may damage the water
softening system.
▶
Only fill the dispenser of the water
softening system with special
dishwasher salt.
¡ Special salt can damage the tub due
to corrosion.
▶
To make sure that any special salt
that escapes is washed out of the
tub, add the special salt to the
dispenser for special salt immedi-
ately before the programme
starts.
1. Unscrew the lid of the dispenser for
special salt and remove.
2. On initial start-up: Fill the dispenser
right up with water.
3. Note:Only use special salt for dish-
washers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dis-
penser.
a
Funnel
1
Fill the dispenser right up with spe-
cial salt. The water in the dispenser
is displaced and forced out.
1
Depending on the appliance specifications
Loading ...
Loading ...
Loading ...